학지사 뉴논문

총 365건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

251.

A facile green reduction of graphene oxide using Annona squamosa leaf extract

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 9 74-80 (7 pages)

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 저
...
- 3,000원
A highly facile and eco-friendly green synthesis of Annona squamosa (custard apple) leaf extract reduced graphene oxide (CRG) nanosheets was achieved by the reduction of graphene oxide (GO). The as-prepared CRG was characterized with X-ray diffraction (XRD), transmission electron microscope (TEM), Fourier-transform infrared spectroscopy (FT-IR), ultraviolet-visible (UV-Vis), X-ray photoelectron spectroscopy (XPS) and Raman spectroscopic techniques. Removal of oxygen containing moieties from the...
252.

Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 저
...
- 4,700원
In this study, Fe-Ni bimetallic catalyst supported on kaolin is prepared by a wet impregnation method. The effects of mass of kaolin support, pre-calcination time, pre-calcination temperature and stirring speed on catalyst yields are examined. Then, the optimal supported Fe-Ni catalyst is utilised to produce multi-walled carbon nanotubes (MWCNTs) using catalytic chemical vapour deposition (CCVD) method. The catalysts and MWCNTs prepared using the optimal conditions are characterized using high...
253.

In-situ magnetization measurements and ex-situ morphological analysis of electrodeposited cobalt onto chemical vapor deposition graphene/SiO₂/Si

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 3 16-22 (7 pages)

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 저
...
- 3,000원
Cobalt was electrodeposited onto chemical vapor deposition (CVD) graphene/Si/SiO2 substrates, during different time intervals, using an electrolyte solution containing a low concentration of cobalt sulfate. The intention was to investigate the details of the deposition process (and the dissolution process) and the resulting magnetic properties of the Co deposits on graphene. During and after electrodeposition, in-situ magnetic measurements were performed using an (AGFM). These were followed by...
254.

Mechanical properties of epoxy composites reinforced with ammonia-treated graphene oxides

Mi-Seon Park, Sangmin Lee, Young-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 1 1-7 (7 pages)

Mi-Seon Park, Sangmin Lee, Young-Seak Lee 저
...
- 3,000원
used to modify GO. Nitrogen functional groups were introduced on the GO surfaces without significant structural changes. The ammonia-treated GO-based epoxy composites exhibited interesting changes in their mechanical properties related to the presence of nitrogen functional groups, particularly amine (C-NH2) groups on the GO surfaces. The highest tensile and impact strength values were 42.1 MPa and 12.3 J/m, respectively, which were observed in an epoxy composite prepared with GO treated with a...
255.

Activating needle coke to develop anode catalyst for direct methanol fuel cell

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 7 47-52 (6 pages)

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 저
...
- 3,000원
Physical and electrochemical qualities were analyzed after KOH activation of a direct methanol fuel cell using needle coke as anode supporter. The results of research on support loaded with platinum-ruthenium suggest that an activated KOH needle coke container has the lowest onset potential and the highest degree of catalyst activity among all commercial catalysts. Through an analysis of the CO stripping voltammetry, we found that KOH activated catalysis showed a 21% higher electrochemical...
256.

Morphologies and surface properties of cellulose-based activated carbon nanoplates

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 5 32-38 (7 pages)

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 저
...
- 3,000원
In this study, cellulose nanoplates (CNPs) were fabricated using cellulose nanocrystals obtained from commercial microcrystalline cellulose (MCC). Their pyrolysis behavior and the characteristics of the product carbonaceous materials were investigated. CNPs showed a relatively high char yield when compared with MCC due to sulfate functional groups introduced during the manufacturing process. In addition, pyrolyzed CNPs (CCNPs) showed more effective chemical activation behavior compared with...
257.

Nanoporous carbon synthesized from grass for removal and recovery of hexavalent chromium

Shahin A. Pathan, Nancy S. Pandita 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 2 10-18 (9 pages)

Shahin A. Pathan, Nancy S. Pandita 저
...
- 3,000원
Nanoporous carbon structures were synthesized by pyrolysis of grass as carbon precursor. The synthesized carbon has high surface area and pore volume. The carbon products were acid functionalized and characterized by Fourier transform infrared spectroscopy, X-ray diffraction, Brunauer?Emmett?Teller, transmission electron microscopy, and Energy Dispersive X-ray microanalysis. Acid functionalized nanoporous carbon was explored for use in removal of toxic Cr(VI) ions from aqueous media. An...
258.

Thermoelectric properties of carbonaceous solids

Francesco Miccio 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 14 107-111 (5 pages)

Francesco Miccio 저
...
- 1,500원
259.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
the variables has been emphasized for each characteristic. The results show that thicker carbon fiber can be obtained with a smaller entry angle, a higher spinning temperature, a reduced winding speed, and an increased extrusion pressure. The winding speed was found to be the most significant factor in relation to the fiber diameter. While it was observed that thicker carbon fiber generally shows improved preferred orientation, the most important variable affecting the preferred orientation was...
260.

Effects of electrochemical oxidation of carbon fibers on interfacial shear strength using a micro-bond method

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 4 32-39 (8 pages)

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 저
...
- 3,000원
In this work, we studied the effects of electrochemical oxidation treatments of carbon fibers (CFs) on interfacial adhesion between CF and epoxy resin with various current densities. The surface morphologies and properties of the CFs before and after electrochemical-oxidation-treatment were characterized using field emission scanning electron microscopy, atomic force microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and single-fiber contact angle. The...

한주간 이슈검색어