학지사 뉴논문

총 420건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

301.

Mesophase formation behavior in petroleum residues

Subhash Kumar, Manoj Srivastava 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 3 171-182 (12 pages)

Subhash Kumar, Manoj Srivastava 저
...
- 4,100원
Mesophase pitch is an important starting material for making a wide spectrum of industrial and advanced carbon products. It is produced by pyrolysis of petroleum residues. In this work, mesophase formation behavior in petroleum residues was studied to prepare environmentally- benign mesophase pitches, and the composition of petroleum residues and its influence on the mesophase formation was investigated. Two petroleum residues, i.e., clarified oil s (CLO-1, CLO-2) obtained from fluid catalytic...
302.

Effects of cross-linking methods for polyethylene-based carbon fibers: review

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 24 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 2 147-170 (24 pages)

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 저
...
- 5,300원
interest in the use of carbon fiber reinforced plastic (CFRP) in aerospace, renewable energy and other industries, due to its low weight and relatively good mechanical properties compared with traditional metals. However, due to the high cost of petroleum-based precursors and their associated processing costs, CF remains a specialty product and as such has been limited to use in high-end aerospace, sporting goods, automotive, and specialist industrial applications. The high cost of CF is a...
303.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
responses of the CFRP composite plates were significantly affected by the laminate stacking sequences. Three types of specimens, specifically quasi-isotropic, unidirectional, and cross-ply, were tested by a constant impact carrying the same impact energy level. An impact load of 3.44 kg, corresponding to 23.62 J, was applied to the center of each plate supported at the boundaries. The unidirectional composite plate showed the worst impact resistance and broke completely into two parts; this was...
304.

Effect of surface modification of carbon felts on capacitive deionization for desalination

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 4 93-100 (8 pages)

Jong-Ho Lee, Hong-Joo Ahn, Donghwan Cho, Jeong-Il Youn, Young-Jig Kim, Han-Jun Oh 저
...
- 3,000원
Surface modified carbon felts were utilized as an electrode for the removal of inorganic ions from seawater. The surfaces of the carbon felts were chemically modified by alkaline and acidic solutions, respectively. The potassium hydroxide (KOH) modified carbon felt exhibited high Brunauer-Emmett-Teller (BET) surface areas and large pore volume, and oxygencontaining functional groups were increased during KOH chemical modification. However, the BET surface area significantly decreased by nitric...
305.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
Activated carbons (ACs) were prepared by activation of coal tar pitch (CTP) in the range of 700°C-1000°C for 1-4 h using potassium hydroxide (KOH) powder as the activation agent. The optimal activation conditions were determined to be a CTP/KOH ratio of 1:4, activation temperature of 900°C, and activation time of 3 h. The obtained ACs showed increased pore size distribution in the range of 1 to 2 nm and the highest specific capacitance of 122 F/g in a two-electrode system with an organic...
306.

Conducting and interface characterization of carbonate-type organic electrolytes containing EMImBF4 as an additive against activated carbon electrode

Mingyeong Kim, Kyungmin Kim and Seok Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 8 51-56 (6 pages)

Mingyeong Kim, Kyungmin Kim and Seok Kim 저
...
- 3,000원
Carbonate-type organic electrolytes were prepared using propylene carbonate (PC) and dimethyl carbonate (DMC) as a solvent, quaternary ammonium salts, and by adding different contents of 1-ethyl-3-methyl imidazolium tetrafluoroborate (EMImBF4). Cyclic voltammetry and linear sweep voltammetry were performed to analyze conducting behaviors. The surface characterizations were analyzed by scanning electron microscopy method and X-ray photoelectron spectroscopy. From the experimental results,...
307.

Preparation of novolac-type phenol-based activated carbon with a hierarchical pore structure and its electric double-layer capacitor performance

Dayoung Lee, Jin-Young Jung, Mi-Seon Park, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 6 192-197 (6 pages)

Dayoung Lee, Jin-Young Jung, Mi-Seon Park, Young-Seak Lee 저
...
- 3,000원
A hierarchical pore structured novolac-type phenol based-activated carbon with micropores and mesopores was fabricated. Physical activation using a sacrificial silicon dioxide (SiO2) template and chemical activation using potassium hydroxide (KOH) were employed to prepare these materials. The morphology of the well-developed pore structure was characterized using field-emission scanning electron microscopy. The novolac-type phenol-based activated carbon retained hierarchical pores (micropores...
308.

Study on lowering the percolation threshold of carbon nanotube-filled conductive polypropylene composites

Seung Bin Park, Moo Sung Lee, Min Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 8 117-124 (8 pages)

Seung Bin Park, Moo Sung Lee, Min Park 저
...
- 3,000원
and compression molding. The percolation threshold (Φc) of the MWCNT-PP composites was most successfully lowered using the mechanofusion process than with any other mixing method (2-5 wt%). The mechanofusion process was found to enhance formation of a percolation network structure, and to ensure a more uniform state of dispersion in the CPCs. The immiscible-polymer blends were prepared by melt mixing (internal mixer) poly(vinylidene fluoride) (PVDF, PP/PVDF, volume ratio 1:1) filled with MWCNT.
309.

My life and carbon

peter A. Thrower 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 1 1-5 (5 pages)

peter A. Thrower 저
...
- 1,500원
to study how high-energy neutron radiation affected graphite. I was given an assistant named Barry Sheldon to work with me. My first task was to read a pile of papers and reports dealing with the effects of radiation damage on nuclear graphite, including stored-energy release and the recent annealing of the graphite core in one of the on-site reactors. There were several internal reports about dimensional changes produced by irradiation, and other property changes were being systematically and...
310.

Preparation and characterization of microporous NaOH activated carbons from hydrofluoric acid leached rice husk and its application for lead(II) adsorption

A. F. Hassan, A. M. Youssef 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 8 57-66 (10 pages)

A. F. Hassan, A. M. Youssef 저
...
- 3,000원
Three activated carbons (ACs) were prepared using NaOH (N) as an activating agent. Hydrofluoric acid pre-leached rice husk was used as a precursor. After leaching, the precursor was washed with distilled water, dried, crushed, and then sieved; a size fraction of 0.3-0.5 mm was selected for carbonization in the absence of air at 600°C. The carbonization product (LC) was mixed with NaOH at ratios of 1:2, 1:3, and 1:4 (wt of LC: wt of NaOH) and the produced ACs after activation at 800°C were...

한주간 이슈검색어