학지사 뉴논문

총 920건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

691.

Nanoporous graphene oxide membrane and its application in molecular sieving

S. Mahmood Fatemi, Masoud Arabieh, Hamid Sepehrian 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 4 183-191 (9 pages)

S. Mahmood Fatemi, Masoud Arabieh, Hamid Sepehrian 저
...
- 3,000원
Gas transport through graphene-derived membranes has gained much interest recently due to its promising potential in filtration and separation applications. In this work, we explore Kr-85 gas radionuclide sequestration from natural air in nanoporous graphene oxide membranes in which different sizes and geometries of pores were modeled on the graphene oxide sheet. This was done using atomistic simulations considering mean-squared displacement, diffusion coefficient, number of crossed species of...
692.

Mesophase formation behavior in petroleum residues

Subhash Kumar, Manoj Srivastava 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 3 171-182 (12 pages)

Subhash Kumar, Manoj Srivastava 저
...
- 4,100원
Mesophase pitch is an important starting material for making a wide spectrum of industrial and advanced carbon products. It is produced by pyrolysis of petroleum residues. In this work, mesophase formation behavior in petroleum residues was studied to prepare environmentally- benign mesophase pitches, and the composition of petroleum residues and its influence on the mesophase formation was investigated. Two petroleum residues, i.e., clarified oil s (CLO-1, CLO-2) obtained from fluid catalytic...
693.

Influence of Nitrogen moieties on CO2 capture of Carbon Aerogel

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 9 57-61 (5 pages)

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 저
...
- 1,500원
Carbon aerogel is a porous carbon material possessing high porosity and high specific surface area. Nitrogen doping reduced the specific surface area and micropores, but it furnished basic sites to improve the CO2 selectivity. In this work, N-doped carbon aerogels were prepared with different ratios of resorcinol/melamine by using the sol-gel method. The morphological properties were characterized by scanning electron microscopy (SEM). Nitrogen content was studied by X-ray photoelectron...
694.

An overview of new oxidation methods for polyacrylonitrile?based carbon fibers

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 2 11-18 (8 pages)

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 저
...
- 3,000원
The process of oxidizing polyacrylonitrile (PAN)-based carbon fibers converts them into an infusible and non-flammable state prior to carbonization. This represents one of the most important stages in determining the mechanical properties of the final carbon fibers, but the most commonly used methods, such as thermal treatment (200°C to 300°C), tend to waste a great deal of process time, money, and energy. There is therefore a need to develop more advanced oxidation methods for PAN precursor...
695.

Carbon nanotubes synthesis using diffusion and premixed flame methods: a review

Garima Mittal, Vivek Dhand, Kyong Yop Rhee, Hyeon-Ju Kim and Dong Ho Jung 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 1 1-10 (10 pages)

Garima Mittal, Vivek Dhand, Kyong Yop Rhee, Hyeon-Ju Kim and Dong Ho Jung 저
...
- 3,000원
In recent years, flame synthesis has absorbed a great deal of attention as a combustion method for the production of metal oxide nanoparticles, carbon nanotubes, and other related carbon nanostructures, over the existing conventional methods. Flame synthesis is an energyefficient, scalable, cost-effective, rapid and continuous process, where flame provides the necessary chemical species for the nucleation of carbon structures (feed stock or precursor) and the energy for the production of carbon...
696.

A study on elemental mercury adsorption behaviors of nanoporous carbons with carbon dioxide activation

Kyong-Min Bae and Soo-Jin Park 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 10 295-298 (4 pages)

Kyong-Min Bae and Soo-Jin Park 저
...
- 1,500원
In this work, nanoporous carbons (NPCs) were prepared by the self-assembly of polymeric carbon precursors and block copolymer template in the presence of tetraethyl orthosilicate and colloidal silica. The NPCs’ pore structures and total pore volumes were analyzed by reference to N2/77 K adsorption isotherms. The porosity and elemental mercury adsorption of NPCs were increased by activation with carbon dioxide. It could be resulted that elemental mercury adsorption ability of NPCs depended on...
697.

Effects of phosphorus content and operating temperature on the electrochemical performance of phosphorus-doped soft carbons

Eun Hee Kim and Yongju Jung 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 7 277-281 (5 pages)

Eun Hee Kim and Yongju Jung 저
...
- 1,500원
of the soft carbons was extensively investigated. The P-doped soft carbons exhibited greatly enhanced discharge capacities and outstanding rate capabilities with increasing phosphorus content. In addition, the influence of temperature on the electrochemical behaviors of the soft carbons was investigated in a wide temperature range of 25°C to 50°C. Surprisingly, the electrochemical properties of the pristine and P-doped soft carbons were highly sensitive to the operating temperature, unlike...
698.

Modification of isotropic coal-tar pitch by acid treatments for carbon fiber melt-spinning

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 3 247-254 (8 pages)

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 저
...
- 3,000원
In this work, thermal treatment accompanied with different acid treatments was applied to a commercial coal tar pitch (CTP) to obtain a spinnable precursor pitch for carbon fiber. In the case of thermal treatment only, a relatively high reaction temperature of between 380°C and 400°C was required to obtain a softening point (SP) range of 220°C-260°C and many meso-phase particles were created during the application of high reaction temperature. When nitric acid or sulfuric acid treatment was...
699.

Preparation of pitch from pyrolized fuel oil by electron beam radiation and its melt-electrospinning property

Jin-Young Jung, oung-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 10 129-135 (7 pages)

Jin-Young Jung, oung-Seak Lee 저
...
- 3,000원
Spinnable pitch for melt-electrospinning was obtained from pyrolized fuel oil by electron beam (E-beam) radiation treatment. The modified pitch was characterized by measuring its elemental composition, softening point, viscosity, molecular weight, and spinnability. The softening point and viscosity properties of the modified pitch were influenced by reforming types (heat or E-beam radiation treatment) and the use of a catalyst. The softening point and molecular weight were increased in...
700.

Microwave heating of carbon-based solid materials

Teawon Kim, Jaegeun Lee, Kun Hong Lee 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 2 15-24 (10 pages)

Teawon Kim, Jaegeun Lee, Kun Hong Lee 저
...
- 3,000원
As a part of the electromagnetic spectrum, microwaves heat materials fast and efficiently via direct energy transfer, while conventional heating methods rely on conduction and convection. To date, the use of microwave heating in the research of carbon-based materials has been mainly limited to liquid solutions. However, more rapid and efficient heating is possible in electron-rich solid materials, because the target materials absorb the energy of microwaves effectively and exclusively....

한주간 이슈검색어