자료유형
발행기관
- 한국탄소학회(67)
- 대한생리학회-대한약리학회(18)
- 한국식물병리학회(11)
- 대한수의학회(8)
- 대한기계학회(6)
- 테크노프레스(6)
- 한국열환경공학회(4)
- 대한용접접합학회(3)
- 대한치과이식임플란트학회(3)
- 대한전기학회(2)
- 대한치과교정학회(2)
- 한국습지학회(2)
- 한국윤활학회(2)
- 한국항공우주학회(2)
- 경인교육대학교 교육연구원(1)
- 대한생리학회(1)
- 대한신경정신의학회(1)
- 물리치료재활과학회(1)
- 복식문화학회(1)
- 인문사회과학기술융합학회(1)
- 한국강구조학회(1)
- 한국구조물진단유지관리공학회(1)
- 한국기초간호학회(1)
- 한국도로학회(1)
- 한국비파괴검사학회(1)
- 한국암반공학회(1)
- 한국유화학회(1)
- 한국청각언어재활학회(1)
- 한국콘크리트학회(1)
- 한국통신학회(1)
간행물
- CARBON LETTERS(67)
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(18)
- THE PLANT PATHOLOGY JOURNAL (9)
- JOURNAL OF VETERINARY SCIENCE(5)
- STRUCTURAL ENGINEERING AND MECHANICS : AN INTERNATIONAL JOURNAL(5)
- 열환경공학(4)
- JOURNAL OF DENTAL IMPLANT RESEARCH(3)
- KOREAN JOURNAL OF VETERINARY RESEARCH(구 대한수의학회지)(3)
- JOURNAL OF ELECTRICAL ENGINEERING & TECHNOLOGY(2)
- JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY(2)
- THE KOREAN JOURNAL OF ORTHODONTICS(2)
- 대한기계학회논문집(2)
- 대한기계학회론문집. TRANSACTIONS OF THE KOREAN SOCIETY OF MECHANICAL ENGINEERS. A. A(2)
- 대한용접학회지(2)
- 식물병연구(2)
- 윤활학회지(2)
- 한국습지학회지(2)
- 한국항공우주학회지(2)
- AUDIOLOGY AND SPEECH RESEARCH(1)
- GEOSYSTEM ENGINEERING(1)
- JOURNAL OF KOREAN BIOLOGICAL NURSING SCIENCE(1)
- PHYSICAL THERAPY REHABILITATION SCIENCE(1)
- STEEL & COMPOSITE STRUCTURES : AN INTERNATIONAL JOURNAL(1)
- 교육논총(1)
- 구조물진단학회지(1)
- 대한생리학회지(1)
- 대한용접-접합학회지(1)
- 복식문화연구(1)
- 비파괴검사학회지(1)
- 신경정신의학(1)
- 예술인문사회융합멀티미디어논문지(1)
- 콘크리트학회논문집(1)
- 한국강구조학회 논문집(1)
- 한국도로학회논문집(1)
- 한국유화학회지(1)
- 한국통신학회논문지. THE JOURNAL OF KOREA INFORMATION AND COMMUNICATIONS SOCIETY. 무선통신(1)
-
Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin
Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)
In this study, Fe-Ni bimetallic catalyst supported on kaolin is prepared by a wet impregnation method. The effects of mass of kaolin support, pre-calcination time, pre-calcination temperature and stirring speed on catalyst yields are examined. Then, the optimal supported Fe-Ni catalyst is utilised to produce multi-walled carbon nanotubes (MWCNTs) using catalytic chemical vapour deposition (CCVD) method. The catalysts and MWCNTs prepared using the optimal conditions are characterized using high... -
Thermoelectric Seebeck and Peltier effects of single walled carbon nanotube quantum dot nanodevice
H. A. El-Demsisy, M. D. Asham, D. S. Louis, A. H. Phillips 한국탄소학회 Carbon Letters 8 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 2 8-15 (8 pages)
The thermoelectric Seebeck and Peltier effects of a single walled carbon nanotube (SWCNT) quantum dot nanodevice are investigated, taking into consideration a certain value of applied tensile strain and induced ac-field with frequency in the terahertz (THz) range. This device is modeled as a SWCNT quantum dot connected to metallic leads. These two metallic leads operate as a source and a drain. In this three-terminal device, the conducting substance is the gate electrode. Another metallic gate... -
Effect of acid catalysts on carbonization temperatures for ordered mesoporous carbon materials
Jeong Kuk Shon, Xing Jin, Yun Seok Choi, Jong Gu Won, Yoon Kyung Hwang, Dae Jong You, Chengbin Li, Ji Man Kim 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2016, Vol.20 10 66-71 (6 pages)
of the OMC materials, for which the nature of the carbon precursors affects the conductivity, porosity and surface functionality of the carbon frameworks [17-19]. However, nano-replication methods for OMC materials, based on a conventional thermal process at high temperature (typically above 900°C), are time- and energy-consuming processes. In order to oligomerize or polymerize the carbon precursors before the carbonization, an aging process should also be carried out in the presence of acid... -
Adsorptive removal of atmospheric pollutants over Pyropia tenera chars
Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 10 79-88 (10 pages)
As a replacement for activated carbon, biochar was synthesized and used for the adsorptive removal of formaldehyde and nitrogen oxide. Biochar was produced from the fast pyrolysis of the red marine macro alga, Pyropia tenera. The P. tenera char was then activated with steam, ammonia and KOH to alter its characteristics. The adsorption of formaldehyde, which is one of the main indoor air pollutants, onto the seaweed char was performed using 1-ppm formaldehyde and the char was activated using a... -
Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix
H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved... -
Study on urea precursor effect on the electroactivities of nitrogen-doped graphene nanosheets electrodes for lithium cells
Ki-Yong Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 5 40-46 (7 pages)
Nitrogen-atom doped graphene oxide was considered to prevent the dissolution of polysulfide and to guarantee the enhanced redox reaction of sulfur for good cycle performance of lithium sulfur cells. In this study, we used urea as a nitrogen source due to its low cost and easy preparation. To find the optimum urea content, we tested three different ratios of urea to graphene oxide. The morphology of the composites was examined by field emission scanning electron microscope. Functional groups and... -
Phenylethynyl-terminated polyimide, exfoliated graphite nanoplatelets, and the composites: an overview
Donghwan Cho, Lawrence T. Drzal 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 1 1-11 (11 pages)
high-temperature sizing material for carbon fiber-reinforced polymer matrix composites, PETI-5 imidization and thermal curing behaviors have been extensively investigated based on the phenylethynyl end-group reaction. These studies are reviewed here. In addition, the use of PETI-5 to enhance interfacial adhesion between carbon fibers and a bismaleimide (BMI) matrix, as well as the dynamic mechanical properties of carbon/BMI composites, are discussed. Reports on the thermal expansion behavior of... -
A review: role of interfacial adhesion between carbon blacks and elastomeric materials
Min-Joo Kang, Young-Jung Heo, Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 1 1-10 (10 pages)
Carbon blacks (CBs) have been widely used as reinforcing materials in advanced rubber composites. The mechanical properties of CB-reinforced rubber composites are mostly controlled by the extent of interfacial adhesion between the CBs and the rubber. Surface treatments are generally performed on CBs to introduce chemical functional groups on its surface. In this study, we review the effects of various surface treatment methods for CBs. In addition, the preparation and properties of CB-reinforced... -
One-step synthesis of dual-transition metal substitution on ionic liquid based N-doped mesoporous carbon for oxygen reduction reaction
Ulziidelger Byambasuren, Yukwon Jeon, Dorjgotov Altansukh, Yunseong Ji, Yong-Gun Shul 한국탄소학회 Carbon Letters 12 Pages
한국탄소학회 Carbon Letters 2016, Vol.17 No.1 8 53-64 (12 pages)
Nitrogen (N)-doped ordered mesoporous carbons (OMCs) with a dual transition metal system were synthesized as non-Pt catalysts for the ORR. The highly nitrogen doped OMCs were prepared by the precursor of ionic liquid (3-methyl-1-butylpyridine dicyanamide) for N/C species and a mesoporous silica template for the physical structure. Mostly, N-doped carbons are promoted by a single transition metal to improve catalytic activity for ORR in PEMFCs. In this study, our N-doped mesoporous carbons were...


전체 선택해제

총


