To research the seeding systems and the varieties adapted to mechanization in barley and wheat culture in Korea, the studies were carried out from October, 1969 to June, 1970 at Suwon. In these studies, six kinds of seeding systems of drilling and dibbling that seems to adapted to mechanization were tested as compared with the customary seeding system, furrowing moderately or widely, using three varieties of barley, Suwon ＃18, Barsoy and Buhufng, and three varieties of wheat, Wonkwang, Yucseung ＃3 and Yeungkwang, under the two fertilizer levels of standard and double. The summarize results gained were as follows; 1. Buhung seemed to be the most suitable variety in barley as it yielded the most and matured early and grew the safest. Barsoy suffered from winter injury. 2. Yeungkwang seemed to be the most suitable variety in wheat as it yielded the most and produced the largest grain ani grew the safest, however it matured late. Wonkwang suffered heavily from lodging injury. 3. More yield were produced and there were no increase of cultural dangers except lodging in double fertilizer level. 4. Seeding system of drilling and dibbling seems to be able to put in practice safely under the double fertilizer level when lodging resistant varieties are selected. 5. Rate of yields increase in comparison with the customary seeding system of moderate furrowing were 16 percent in drilling of 20 centimeter spacing, 13 percent in wide furrowing and 12 percent in dibbling of 20 ${ imes}$ 12 centimeter spacing in barley and also 9 percent in wide furrowing, 8 percent in dibbling of 20 ${ imes}$ 12 centimeter spacing and 7 percent in drilling of 20 centimeter spacing in wheat. 6. The most important cause of above yields increase seems to be the increase of spike number per unit area. 7. Yields increase by drilling as compared with furrowing was not caused by higher rate of seeding. 8. The plants matured a bit earlier by drilling and dibbling. 9. Better stands of seedling were fount in dibbling due to the promotion of germination by tramping. 10. An increase of yields will be expected by decreasing the spacing in drilling and dibbling.