기관회원 [로그인]
소속기관에서 받은 아이디, 비밀번호를 입력해 주세요.
개인회원 [로그인]

비회원 구매시 입력하신 핸드폰번호를 입력해 주세요.
본인 인증 후 구매내역을 확인하실 수 있습니다.

회원가입
서지반출
접착심지에 관한 연구
[STEP1]서지반출 형식 선택
파일형식
@
서지도구
SNS
기타
[STEP2]서지반출 정보 선택
  • 제목
  • URL
돌아가기
확인
취소
  • 접착심지에 관한 연구
저자명
성화경
간행물명
대한가정학회지
권/호정보
1973년|11권 3호|pp.276-284 (9 pages)
발행정보
대한가정학회
파일정보
정기간행물|
PDF텍스트
주제분야
기타
이 논문은 한국과학기술정보연구원과 논문 연계를 통해 무료로 제공되는 원문입니다.
서지반출

기타언어초록

An experiment, aimed at finding out the adhesive condition when adhesive non-woven fabrics for padding cloths are used for padding cloths of blouse, has been conducted. Materials used were three different kinds-scoured, sanforized, and permanent pressed- of combined fabrics of polyester and cotton. As for padding cloth material, mixed spinning nonwoven fabrics of polyster and viscose rayon have been used. Adhesive conditions were made each at $120^{circ}C$, $140^{circ}C$, $160^{circ}C$ and $180^{circ}C$, respectively, and adhesive time has been limited to 5, 10, 20, 30, 40 seconds each. External appearance as well as quality have been watched through washing experiment. In case of 12$0^{circ}C$, all experimental materials were separated at the seventh washing and as for $140^{circ}C$, all but the material which has been attached on scoured cloth for 40 seconds were separated. In case of 20 seconds only permanent pressed cloth and sanforized cloth were separated. At 30 and 40 seconds, the adhesive conditions have been maintained up to the seventh washing. In case of 5 seconds $180^{circ}C$it was not turned yellow, but all were separated. In case of 10, 20, 30 and 40 seconds, at above temperature all were turned yellow in the adhesive process. Therefore, the adhesive power could be said strong enough, though it was not very practical. In this experiment, the lower the temperature of iron is, the longer time it has to be touched. At higher temperature however, relatively short time makesn it possible for adhesion and depending upon the finishing methode of cloth, there is slight difference in adhesive power. As a result, the best adhesive condition for all experimental materials is $160^{circ}C$of iron temperature, and the time of adhesion is between 30 and 40 seconds.