No reliable basic data were available on the kinetic friction coefficients between grains and frictional surfaces being used in grain handling equipments in Korea. In order to determine appropriate kinetic friction coefficient between three grains (Tongil, Jinheung, barley) and two surfaces at four levels of moisture content of grain, the laboratory tests using the newly designed experimental apparatus and strain gage measuring system were carried out, and the relationship among factors that affect kinetic friction coefficients of grains were analyzed. The results of this study are summarized as follows ; 1. Kinetic friction coefficient of samples being tested was dependent on surfaces and moisture content of grains . The ranges of them were 0.369-0.512 for Tongil variety , 0.347-0.469 for Jinheung variety, and 0.360-0.502 for barley, respectively. 2. There was a little difference of kinetic friction coefficients between two varieties of rice at the same testing conditions. Because the interaction had been large among treatments , each value of kinetic friction coefficient determined in this study should be used only for the corresponding conditions in this study . 3. Kinetic friction coefficients in creased linearly with increase in moisture content of grains and their regression equations were shown in Table.4. 4. Kinetic friction coefficients on a PVC surfaces was shown a little lower values than on the steel surfaces at various moisture levels, but especially in Jinheung and barley, a big difference was shown.