When the perforated panels are under in-plane shear loads, shear buckling analysis is also necessary because of the presence of stress concentration around holes. To constrain it, we need some reinforcement. The methods of reinforcement are attaching doubler around hole and stiffeners in the arbitary directions. In this paper, two kinds of methods mentioned above are investigated, it is also clarified that which of the two is the more effective reinforcement. For the sake of convenience those arbitary directions were selected parallel ($90^{circ}$) and oblique ($135^{circ}$) to the edge. From the results of the above investigation, following conclusion was obtained. In case of parallel stiffeners, doubler reinforcement gives higher buckling strength than stiffener, however, in case of oblique stiffeners, doubler reinforcement gives higher buckling strength than doubler when the external load direction is known.