Adquate amount of calcia was added to the regent-grade Zirconia body. Here the amount and the form of calcia were 7-21 mol% and regent-grade calcium cabonate respectively. The specimens were fired at 175$0^{circ}C$ for 0, 3, 5 and 7 hours respectively. The phase Strength X-ray diffraction analysis and Scaning electron microscopy. The results were as follows (1) As the additive amount of calcia was increased the firing linear shrinkage apparent density compressive strength and modulus of rupture decreased but the apparent porosity increased. (2) The specimens soaked and containing calcia displayed the grain growth. (3) Monoclinic and cubic zirconia were seen in the sepcimens containing 7 mol% calcia. When without soaking the specimens containing 7-10 mol% calcia had the volume change by monoclinic$ ightleftharpoons$tetragonal transformation. (4) The lattice parameter increased according as the calcia additive was increased. The specimens containing above 19mol% calcia had the costant lattice parameter. The value of that was from 5.1264 to 5.1396 $AA$ in the case of 7 hours soaking.