기관회원 [로그인]
소속기관에서 받은 아이디, 비밀번호를 입력해 주세요.
개인회원 [로그인]

비회원 구매시 입력하신 핸드폰번호를 입력해 주세요.
본인 인증 후 구매내역을 확인하실 수 있습니다.

회원가입
서지반출
FPGA를 이용한 POCSAG 복호기의 설계
[STEP1]서지반출 형식 선택
파일형식
@
서지도구
SNS
기타
[STEP2]서지반출 정보 선택
  • 제목
  • URL
돌아가기
확인
취소
  • FPGA를 이용한 POCSAG 복호기의 설계
저자명
임재영,김건,김영진,김호영,조중휘
간행물명
電子工學會論文誌. Jounnal of the Korea institute of telematics and electronics. A. A
권/호정보
1996년|7호|pp.269-277 (9 pages)
발행정보
대한전자공학회
파일정보
정기간행물|
PDF텍스트
주제분야
기타
이 논문은 한국과학기술정보연구원과 논문 연계를 통해 무료로 제공되는 원문입니다.
서지반출

기타언어초록

This paper has been presented a design of a POCSAG decoder in RT-level VHDL and implemented in a FPGA chip, and tested. In a single clock of 76.8KHz, the decoder receives all the data of the rate of 512/1200/2400bps and has maximum 2-own frames for service enhancement. To improve decoder performance, the decoder uses a preamble detection cosidering 9% frequency tolerance, a SCW detction and a ICW detection at each 4 bit. The decoder also corrects a address data and a message data up to 2 bits and proposes the PF (preamble frequency) error for saving battery. The decoder increases a battery life owing to turn off RF circuits when the preamble signal is detected with nises. The chip has been designed in RT-level VHdL, synthesized into logic gates using power view$^{TM}$ of viewlogic software. The chip has been implemented in an ALTERA EPF81188GC232-3 FPGA chip with 98% usability, and fully tested in shield room and field room. The chip has been proved that the wrong detection numbers of preamble of noises are significantly reduced in the pager system using PDI 2400 through the real field test. The receiving performance is improved by 20% of aaverage, compared with other existing systems.