The SPICE circuit analysis program has a limited math capability and, in general, cannot be used for RF and microwave simulation because a complex arithmetic is required to compute S-parameters from node voltages. This paper presents two test bench models that can be used to obtain node voltages proportional to incident, reflected, and transmitted signals. From SPICE computed node voltages, S-parameters are computed using the math capability of the PSPICE post processor, PROBE, as an example for a low-pass filter consisting of transmission line sections. The results of this example are compared with another high frequency circuit analysis program, TOUCHSTONE. The difference between the results of these two programs in magnitude was less than 0.003 and in phase was a few tenths of a degree. By using these test benchs to simulate a filter, RF and microwave analysis can be made with the SPICE, which can be a cost-effective and readily available computational tool for educators and practicing engineers.