쾌적한 실내환경을 유지하고, 공기조화 설비에 있어서 냉방동안 에너지를 절약하기 위한 실내로 유입되는 냉기의 열유동 특성에 관한 연구이다. 실물 크기의 모형room에 대하여 실내로 유입하는 냉기의 유속(1, 2, 3m/s)과 실내온도와 유입냉기와의 기준온도차(10, 20, $30^{circ}C$)를 변화시키고, 또한 유입구 형상을 아네모스형과 베인형으로 하면서 실내의 온도분포를 파악하여 열유동 특성 및 혼합특성에 대하여 고찰하였다. 연구 결과, 아네모스형이 베인형보다 혼합이 빨리 진행되었고 유입속도에 의한 영향이 기준 온도차에 의한 영향보다 지배적이었다.
A study on a buoyancy effect by the temperature difference between a inner room air and a inflowing cool air and also by Inlet velocity can contribute greatly to enhance performance of air conditioning system, so the study on the distribution characteristics of inflowed cool air is important to analyze the cool air storage in a room. For this study, in the real-sized model room, the temperature differences between inflowing cool air and inner room air are 10, 20, $30^{circ}C$, and the inlet velocities of inflowing cool air are 1, 2, 3m/s respectively as dynamic parameters. Also, a anemos and a vane type diffuser are used as inlet geometric conditions. Following conclusions have been obtained through this study. 1) In case of the anemos type diffuser, it is found that a dimensionless temperature profile is low and the distribution of the inflowed cool air is uniform. and also, all diffuusers have a low temperature of the inner room as increasing the inlet velocity. 2) A mixing takes place rapidly in case of the anemos type diffuser when the temperature difference is low ${Delta}T=10^{circ}C$ and the inletvelocity is high V=3m/s. and the mixing degree is higher with the anemos type diffuser than the vane.
