In robot teleoperation, much research has been carried out to control the slave robot from remote site. One of the essential devices for robot teleoperation is the masterarm, which is a path command generating device worn on human arm. In this paper, a new masterarm based on human kinematics is proposed. Its controller is based on the distributed controller architecture composed of two controller parts: a host controller and a set of satellite controllers. Each satellite controller measures the corresponding joint angle, while the host controller performs forward and inverse kinematics calculation. This distributed controller architecture can make the data updating faster, which allows to implement real-time implementation. The host controller and the satellited controllers are networked via three-wire daisy-chained SPI(Serial Peripheral Interface) protocol, so this architecture makes the electrical wiring very simple, and enhances maintenance. Analytical method for finding three additional unknown joint angles is derived using only three measured angles for each shoulder and wrist, which makes th hardware implementation very simple by minimizing the required number of satellite controllers. Finally, the simulation and experiment results are given to demonstrate the usefulness and performance of the proposed masterarm.