With the wide range of movement, the movement of neck accompanies the body surface change of neck and shoulders. And neck corresponds to the collar of garment, meaning that the body surface change of this part affects the construction of patterns for collars. So the purpose of this study was to manifest the changes of body surface in the neck and shoulder accompanied with the movement of the neck and to draw up the facts worth consideration when constructing the collar pattern. In this study, the draft of body surface of neck and shoulder was drawn up by gypsum method according to the 5 movements (standing at attention, neck bending - front, back, right, left). The length of body surface was measured and analyzed by ANOVA, post hoc test, correlation and regression analysis using SPSS 10.0 for Windows. The variation of the surface of neck was remarkable in the vertical lines than the horizontal ones. So the height of collar should be established considering the range of movement of the neck. It was the raising amount of c.f(center front) of neck and girth of neckbase (back) that were proved to have significantly varied after movement. With correlation analysis done, in every movement, the raising amount of side and the girth of neckbase had remarkably positive relation. The movement of the neck accompanied the variation of body surface in the shoulder as well. It was the part of scapula and side of neckbase that the variation was notable, suggesting that the surplus is needed in these parts.