Yellow loess, Tidal plat sediment, and mud are blown to be high in adsorption though they have great distinction according to the ratio of clay minerals content and their kinds. Thus one of the samples for this study can be obtained by drying of Yellow loess, Tidal plat sediment, and the mud which is semifinished products that are from the progress of heat treatment and making homogeneity which can be found everywhere in our county. Another sample can be prepared by reducing pollutants with the adsorbent and by homing heavy metals of their on. With the samples, noxious heavy metals such as Pb, Cd, and essential trace elements such as Cu, Fe, Mn by each concentration is tested for adsorption according to pH, the kinds of adsorbents and the amount of injection. With the help of these steps, this study shows that the adsorbents, which are green, reducing the additional pollution and low in price, can be found. It also shows that the optimal condition for removing pollutants can be found and the basic materials for treating water can be offered. The results were as follows ; Yellow loess shows the rates of adsorption by more than 50% and Tidal plat sediment and Mud show it by more than 90%. Thus Tidal plat sediment and Mud are higher than Yellow loess the rates of adsorption. The pH should be treated in natural condition because the rates of adsorption of Pb, Cd, Cu, Mn excepting Fe in mud is higher in pH 7 than in pH 3 of Yellow loess, Tidal plat sediment, and Mud. The drying adsorbents are good to use because the rates of adsorption of heavy metals has tendency to be higher in the drying method than in the burning method. It is considered that the more the mont of the injection of the adsorbent is , the higher the rates of adsorption is, and one gram is reasonable for the amount of the injection of Tidal plat sediment and mud. Yellow loess is suitable for the treatment of the water that includes low concentration of heavy metals because it has the lower rate of adsorption as the concentration of noxious heavy metals is higher. It is thought that Tidal plat sediment and Mud is proper for the treatment of the water that includes high concentration of heavy metals because the rates of adsorption has not been changed as the concentration of heavy metals increases.