The objective of this research works is to develop back panel dies of PDP TV with a large size. In order to design the geometry of the dies and an initial size of blank optimally, the finite element analysis has been carried out using AUTOFORM V4.2. The conner radius of the upper trimming area and the distance from the outer line of the blank holder to the outer line of the blank have been selected as design parameters to remove the wrinkling of the trimming area. The results of the analyses have been shown that a feasible product without wrinkles and skid lines can be obtained when the conner radius ranges from 6mm to 8mm and the distance lines in the range of 40-60mm. From the proposed design of the dies and an initial blank size, the final die set of the back panel has been successfully manufactured.