Many rubber products are used in industrial products such as various hoses, rubber belts and oil seals etc. Especially, more then 200 rubber parts are used in the automobile, but design technology of these is largely dependent on Held experiences. These methods brought about too much time and cost in the developing procedures. However, with the help of recent rapid development of non-liner computer analysis, we can develop new sound products at low cost. Therefore in this study, optimizations of design variables such as location and number of gate in order to develop CLIP rubber product made of EPDM were performed by CAE in which Cross-WLF equations are adopted. The validity of proposed variables is evaluated by comparison with real forming results.