The composites were fabricated by adding 0, 15, 30, 45[vol.%] $ZrB_2$ powders as a second phase to SiC matrix. The physical, mechanical and electrical properties of electroconductive SiC ceramic composites by spark plasma sintering(SPS) were investigated. Reactions between ${eta}$-SiC and $ZrB_2$ were not observed in the XRD and the phase analysis of the electroconductive SiC ceramic composites. The relative density of mono ${eta}$-SiC, ${eta}$-SiC+15[vol.%]$ZrB_2$, ${eta}$-SiC+30[vol.%]$ZrB_2$ and ${eta}$-SiC+45[vol.%]$ZrB_2$ composites are respectively 99.24[%], 87.53[%], 96.41[%] and 98.11[%] Phase analysis of the electroconductive SiC ceramic composites by XRD revealed mostly of ${eta}$-SiC, $ZrB_2$ and weakly of $ZrO_2$ phase. The flexural strength showed the lowest of 114.44[MPa] for ${eta}$-SiC+15[vol.%]$ZrB_2$ powders and showed the highest of 210.75[MPa] for composite no added with $ZrB_2$ powders at room temperature. The trend of the mechanical properties of the electroconductive SiC ceramic composites is accorded with the trend of the relative density. The electrical resistivity of the electroconductive SiC ceramic composites decreased with increased $ZrB_2$ contents. The electrical resistivity of mono ${eta}$-SiC, ${eta}$-SiC+15[vol.%]$ZrB_2$, ${eta}$-SiC+30[vol.%]$ZrB_2$ and ${eta}$-SiC+45[vol.%]$ZrB_2$ composites are respectively $4.57{ imes}10^{-1},;2.13{ imes}10^{-1},;2.68{ imes}10^{-2};and;1.99{ imes}10^{-2}[{Omega}{cdot}cm]$ at room temperature. The electrical resistivity of mono ${eta}$-SiC and ${eta}$-SiC+15[vol.%]$ZrB_2$ are negative temperature coefficient resistance(NTCR) in temperature ranges from $25[^{circ}C];to; 100[^{circ}C]$. The electrical resistivity of ${eta}$-SiC+30[vol.%]$ZrB_2$ and ${eta}$-SiC+45[vol.%]ZrB_2$ are positive temperature coefficient resistance(PTCR) in temperature ranges from $25[^{circ}C];to;100[^{circ}C]$. It is convinced that ${eta}$-SiC+30[vol.%]$ZrB_2$ composites by SPS for heater or ignitors can be applied.