To avoid disk waviness and warpage in a hard disk drive, it is desirable for the stress distribution on disks fastened to a spindle motor by a clamp to be uniform in the circumferential direction while sufficient clamping force is maintained. The objective of this work is to find a clamp configuration that minimizes the circumferential stress variation on the disks while maximizing the clamping force. Topology and shape optimization methods were employed to find the optimal clamp configuration. To facilitate the optimization problem, a model for the surface contact between the clamp and the top disk was simplified to a static model where the disk clamp and spring were connected. By incorporating the surface recess, the optimized clamp has equal stiffness in the circumferential direction, except for the four tooling hole areas. Numerical simulation confirmed that the optimized clamp reduced the stress variation by about 78% without sacrificing the clamping force; in fact, it increased the clamping force.