This study aims to develop a highly reproducible, optimal frame design algorithm using variations in the curvature of armscye circumference, which will provide the basics for remodeling the 3D human body shape with the concept of reverse design used to develop total contents for the apparel industry. 1. The results of the experiment proved that ratio value was significantly efficient than absolute value of curvature variation to extract feature points in the armscye circumference 2. For the shoulder(1st and 2nd quadrant) and front armhole(3rd quadrant) parts of the armscye circumference, frame remodeling with the positive point of inflection led to the completion of a highly reproducible frame. 3. Similarly, even for the rear armhole part(4th quadrant) in the armscye circumference, it was found that frame remodeling using the positive maximum point of inflection resulted in highly reproducible body shape with the maximum point of inflection situated within the range of split angles $305^{circ}{sim}330^{circ}$, while frame remodeling using simultaneously the two largest points of inflection including maximum point of inflection led to highly reproducible body shape with the maximum point of inflection out of the range $305^{circ}{sim}330^{circ}$. 4. Based upon the optimal frame design algorithm developed in this study, section-specific feature points in the armscye circumference were extracted depending on the rate of curvature variation and remodeling with spline curves was conducted. The results indicate a remarkably high reproducibility(98.6%) and suggest that the algorithm developed in this study is suitable for human body modeling.