이종 접합재($eta-Si_3N_4/S45C$)의 굽힘강도와 인장강도에 미치는 시험편 형상의 영향을 정량적으로 평가하였다. 평균 굽힘강도와 평균 인장강도는 원형단면 시험편이 4각형 단면 시험편보다 약간 높았다. 또한, 초음파(AE)를 이용하여 균열발생응력을 성공적으로 측정할 수 있었으며, 균열발생응력은 굽힘강도의 60~80% 이었다. 아울러, 세라믹측 접합계면 근처의 잔류응력 측정을 굽힘강도 시험전에 X선 회절법에 의해 실시하였으며, 굽힘강도와 균열발생응력은 잔류응력 증가와 더불어 감소하였다. 마지막으로 인장시험에서 굽힘변형률 성분의 영향을 평가하였으며, 인장강도는 굽힘변형률 성분의 증가와 더불어 감소하고 굽힘강도의 약 80%에 해당되었다.
The effect of specimen geometry on the bending and tensile strengths of dissimilar joints ($eta-Si_3N_4/S45C$) with copper interlayers was evaluated. The average bending strength of specimens with circular cross sections was higher than that of specimens with rectangular cross sections. The crack initiation stress ($sigma_i$) was successfully determined by the acoustic emission (AE) method and was approximately 60~80% of the bending strength. The residual stresses near the interfaces on the ceramic side were measured by X-ray diffraction before conducting the bending test. The bending strength and the crack initiation stress decreased with an increase in the residual stresses. The effect of the bending strain component was evaluated by the tensile testing; the tensile strength decreased with an increase in the bending strain component and was approximately 80% of the bending strength.
