기관회원 [로그인]
소속기관에서 받은 아이디, 비밀번호를 입력해 주세요.
개인회원 [로그인]

비회원 구매시 입력하신 핸드폰번호를 입력해 주세요.
본인 인증 후 구매내역을 확인하실 수 있습니다.

회원가입
서지반출
폐목재 칩을 활용한 목질계 보도포장재의 특성에 대한 기초연구
[STEP1]서지반출 형식 선택
파일형식
@
서지도구
SNS
기타
[STEP2]서지반출 정보 선택
  • 제목
  • URL
돌아가기
확인
취소
  • 폐목재 칩을 활용한 목질계 보도포장재의 특성에 대한 기초연구
저자명
최재진,송진우,Choi. Jae Jin,Song. Jin Woo
간행물명
大韓土木學會論文集, Journal of the Korean Society of Civil Engineers, D. 교통공학, 도로공학, 시공관리, 정보기술, 지역 및 도시계획, 철도공학, 측량 및 지형공간정보공학
권/호정보
2011년|31권 |pp.413-420 (8 pages)
발행정보
대한토목학회
파일정보
정기간행물|
PDF텍스트
주제분야
기타
이 논문은 한국과학기술정보연구원과 논문 연계를 통해 무료로 제공되는 원문입니다.
서지반출

기타언어초록

건설현장에서 나오는 폐목재 또는 활용가치가 낮은 벌목지에서 발생하는 나무뿌리와 가지 등의 임목폐기물을 분쇄한 목재 칩을 우레탄 수지로 결합시킨 보도용 포장재를 제안하기 위한 실험을 실시하였다. 시험체는 재료혼합비율로서 건설폐목재 칩 및 임목폐기물 칩에 대한 우레탄 수지의 질량비를 0.5, 0.75, 1.0의 3수준으로 정하고 재료 계량 후 믹서로 혼합, 성형한 다음 7일이 경과하였을 때 인장강도 시험, 골프공과 스틸볼을 이용한 탄력성 시험, 투수계수 측정 및 가연성 시험을 실시하였다. 실험결과 공기중 건조상태에서 시험체의 인장강도는 0.2~1.1MPa의 범위를 나타냈으며 재령 7일 이후의 강도 변화는 나타나지 않았다. 그러나 침수시켰을 때 강도가 저하되었으며 그 강도의 저하비율은 우레탄 수지의 사용량이 적을수록 크게 되므로 강우 등에 의한 수분 침투를 고려하여 폐목재 칩에 대한 수지의 질량비는 0.75 이상으로 하는 것이 바람직하다고 판단된다. 탄력성 시험결과로서 폐목재 칩과 우레탄 수지를 사용한 시험체의 GB계수와 SB계수는 20% 이하의 낮은 값으로 측정되어 보도용 포장재로서 우수한 특성을 나타냈다. 또한 투수계수는 모든 배합의 시험체에서 0.5mm/sec 이상으로, 투수성 포장재에 있어서 시공 후 요구되는 일반적인 투수계수의 기준값을 상회하였으며, 목질계 포장재의 가연성은 실용상 특별히 문제가 되지는 않을 것으로 판단되었다.

기타언어초록

An experiment was conducted to suggest the road pavement material combining wooden chip crushed from little useful roots and branches from logging sites or wood waste from construction sites with urethane resin. For the specimen, the mass ratio of urethane resin to construction wood waste chip/lumber waster chip was set to three different levels of 0.5, 0.75, and 1.0, which was measured, mixed with mixer, and molded; 7 days after, tensile strength test, elasticity test using golf balls and steel balls, permeability coefficient measurement, and flammability test were executed. As the result, the tensile strength of the specimen at the dry state in the air exhibited the range of 0.2-1.1MPa, and there was no change after 7 days of aging. When submerged in water, however, the strength was partially diminished; the diminishing rate was greater for less urethane resin usage, and therefore it appears desirable to set the mass ratio of resin to the wood waste chip over 0.75 to consider the moisture intrusion by precipitation and such. As the result of elasticity test, the GB and SB coefficients of the specimen using wood waste chips and urethane resin were measured to be low at below 20%, exhibiting excellent elasticity as road pavement material. Also, the permeability coefficient was over 0.5mm/sec for specimens of all combinations, exceeding the standard value required after construction for permeable pavement material, and the flammability of wood-type pavement material was evaluated to have no practical issues.