The purpose of this study is to quantitatively analyze the impacts of the distribution of easing contraction of the sleeve on the external appearance of bodice and sleeve through virtual clothing simulation. Virtual clothing is conducted by differentiating the sleeve easing in accordance with the experimental condition of bodice and sleeve that are followed by draping. And then the evaluation is carried out. As a result of an analysis of the similarity between the virtual garment and the actual clothing, the whole external appearance of the bodice and sleeve was expressed similarly. The external appearance according to the distribution of easing contraction got better as the easing contraction of sleeve was concentrated on sleeve cap in front while the appearance was better at the back as it was more gently distributed than in the front. In a comparison of armhole form, the clothing of which the top of it was most similar to S0 was S4 in which the gap between the armhole and the arm was the least and the front and rear silhouette fell relatively well. In a comparison between the position of bust circumference line and that of the sleeve base line, the front of the sleeve matched the bust circumference line as the easing contraction was distributed close to the center of the sleeve cap while in the back, the sleeve base line and the bust circumference line matched when some easing contraction ratio was added close to the armpit point. The cross section figures of garment space of the shoulder, the margin was evenly distributed in S4 or S5 with differing distributions of easing contraction in the front and the back. This study is significant in that it supplies the objective baseline data which makes a novice more able to make a good external appearance of the sleeve.