Glass fiber reinforced polypropylene composites were compounded with a twin-screw extruder and injection molded. Fiber length distribution study showed that more fiber degradation occurred during processing of the composites with higher fiber loading. Dynamic mechanical analysis carried out showed that magnitudes of storage and loss modulus of composites are improves with the presence of the glass fiber in the system. The incorporation of fibers into the composites has slightly shifted the glass transition temperature to lower values. On the other hand, the presence of the glass fiber reduces the magnitude of tan ${delta}$ at ${alpha}$-transition dramatically due to the strengthening effect by the fibers. From impact test, it was found that increment in glass fiber loading leads to an increase in peak load, critical strain energy release rate and critical stress intensity factor indicating the improvement in the material toughness. However, there was no significant change observed in fracture energy. With respect to increasing in specimen geometry, despite an improvement in peak load and fracture energy of the impact specimen, the critical strain energy release rate and critical stress intensity factor values were decreased. On the other hand, increase in test temperature resulted in reduction of peak load and critical stress intensity factor due to increment in material ductility, whereby fracture energy and critical strain energy release rate improved.