The facial asymmetries include maxillary, mandibular, and chin asymmetries, although the most common deformity is primarily in the mandible. Common causes of this type of asymmetry can include asymmetric growth of the condyle or the mandible. In these patients, the location of the Me would be deviated to the shorter side because of the asymmetric growth of the mandible, and, commonly, the maxillary occlusal plane would be tilted toward the deviated side because the maxilla likely grows asymmetrically according to the pattern of asymmetric mandibular growth. Three-dimensional CT images are ideal for evaluating the size and location of anatomic structures, and such reconstructed images allow the use of software that can show anatomic structures from numerous angles, allowing actual measurements of distances and angles without problems of magnification, distortion, or superimposition caused by 2-dimensional imaging. In the present study using 3D-CT imaging, the 8 parameters, including measurements of the upper midline deviation, maxillary canting in the canine and first molar regions, width of the upper arch, width of the mandible at the Go, vertical length of the ramus, inclination of the ramus, and deviation of the Me were easily measured. The dentition should be orthodontically decompensated and dental midline should ensure incisor midlines positioned in the midline of each jaw before surgical correction. Surgical correction could be considered such as canting or yawing correction in the frontal or horizontal aspect, respectively.