As the gerotor set with ideal profile meshes too tight, the reduction in the size of the rotor is generally adopted for a smooth operation. In this paper, a method of the profile modification for providing clearances was proposed. The meshing properties of the gerotor were analyzed and the non-boundary section of the inner rotor was identified, which denoted that the adjacent chambers were in the same pressure state. Clearances were imposed on the non-boundary section of the inner rotor, and then the profile of that section was modified as a composite curve of arcs. The other sections of the inner rotor were also interpolated as arcs. Thus, the whole profile of the inner rotor was designed as a composite curve of arcs.